IE实验中的多播资料

Helper-map for Broadcast to multicast conversion and vice versa. The following is an example which illustrates the use of the helper-map command at the first-hop and the last-hop, to convert a broadcast stream directed to port 2000 to a mu

　　Helper-map for Broadcast to multicast conversion and vice versa.
　　The following is an example which illustrates the use of the helper-map command at the first-hop and the last-hop, to convert a broadcast stream directed to port 2000 to a multicast stream and back.
　　
　　On the first hop router
　　-----------------------
　　The following example converts broadcast streams to port 2000 to a multicast stream(G = 224.5.5.5)
　　
　　int /* incoming interface of broadcast stream */
　　ip multicast helper-map broadcast 224.5.5.5 101
　　ip pim dense
　　.....
　　
　　ip forward-protocol udp 2000
　　access-list 101 permit udp any any eq 2000
　　access-list 101 deny udp any any
　　
　　On the last hop router
　　---------------------
　　
　　int <...> /* incoming interface of multicast stream */
　　ip multicast helper-map 224.5.5.5 178.21.34.255 101
　　ip pim dense
　　.....
　　
　　
　　ip forward-protocol udp 2000
　　access-list 101 permit udp any any eq 2000
　　access-list 101 deny udp any any
　　
　　Note:
　　o Configuring the multicast helper map command (to convert multicast to
　　broadcast) will also automatically configure "ip igmp join-group "
　　on the interface. The router must be joined to the multicast group to be translated to a broadcast address.
　　o In Cisco IOS 12.0, it is necessary to configure the interface command "ip directed-broadcast" along with helper-map command. By default, it is turned off.
　　

【责编:admin】